Cold storage logistics scenarios usually maintain a continuous low temperature environment ranging from -30℃ to 0℃, accompanied by high air humidity, which puts forward higher requirements for the operation stability of material handling equipment. As Jianshu New Energy, we are specialized in the supply of BYD electric forklifts, and we have summed up practical performance and operation notes for lithium electric forklifts serving cold storage scenarios based on long-term front-line service experience, to help staff complete handling work smoothly in low temperature environment.
Before the lithium electric forklift enters the formal cold storage operation area, it is necessary to complete the full pre-operation inspection work first. Operators need to check the remaining power level of the lithium battery, confirm that the surface of the power module, operation panel and walking structure has no obvious water stain or damage, test the flexibility of the lifting mechanism and walking steering function, and confirm that the tire surface has no excessive debris adhesion before entering the cold storage area. Do not bring ice blocks or large amount of open water into the low temperature operation area with the equipment, to avoid ice accumulation at the movable structure gap and cause operation jamming.
During the continuous operation in the cold storage area, operators need to pay close attention to the real-time power change of the lithium electric forklift. Affected by the low temperature environment, the discharge efficiency of lithium battery will show reasonable fluctuation within the allowable range of product design, so please avoid using the equipment under the state of low power for a long time. If the equipment needs to work in the cold storage for more than 4 hours continuously, it is recommended to drive the forklift to the normal temperature transition buffer area for a 10 to 15 minutes rest every 2 to 3 hours, to slow down the performance consumption of the power module in the long-term ultra-low temperature state.
After the lithium electric forklift finishes the cold storage operation task and returns to the normal temperature area, do not carry out the charging operation immediately. It is recommended to park the equipment in the dry and ventilated transition area for more than 30 minutes, until the condensation on all surfaces of the fuselage is completely volatilized, then carry out the subsequent maintenance and charging operation, so as to avoid the hidden danger of short circuit of electrical components caused by condensed water penetration. If you have more demand for cold storage special lithium electric forklift products or operation consultation, you can send an email to 17399989919@163.com for further communication.
