When you invest in electric forklifts for daily warehouse, logistics or industrial material handling scenarios, mastering standardized forklift lifting procedure is a core prerequisite to guarantee operation safety, extend equipment service life and optimize work efficiency. As a professional provider specialized in BYD electric forklifts, Jianshu New Energy offers targeted guidance for all users to get familiar with standard operation rules.
First, complete all pre-lifting preparation checks before starting any lifting operation. Confirm the load weight does not exceed the rated load capacity of the electric forklift, check if the goods are placed stably on the pallet without tilting or loose parts that may fall off. Inspect the fork arm surface, lifting chain, limit switch and hydraulic system for any abnormal wear, oil leakage or malfunction, adjust the fork distance to match the pallet width to ensure even stress on both sides of the load. Operators must wear designated safety protective gear, confirm the operation route has no obstacles, pedestrians or soft ground that may cause the vehicle to slip.
Second, follow the standard lifting operation steps strictly after all pre-check items are passed. Keep the vehicle body in a horizontal and stable state, insert the fork arms fully into the bottom of the pallet, make sure the fork top does not touch the goods on the upper layer. Tilt the gantry slightly backward first, start the hydraulic lifting system to raise the goods 10 to 20 centimeters off the ground, pause for 2 to 3 seconds to check the stability of the load and the operation status of the lifting system. If no abnormal condition is found, continue to lift the goods to the required operation height, keep the gantry tilted backward properly during the whole process to prevent the goods from sliding forward. Do not adjust the lifting speed sharply, avoid sudden acceleration or sudden stop of the vehicle when the goods are lifted to a high position.
Third, do a good job in post-lifting operation and daily maintenance. After finishing the lifting and placement work, lower the fork arms slowly to the position 10 to 15 centimeters above the ground, restore the gantry to a vertical state before driving the forklift to the designated parking area. After parking, lower the fork arms to fully contact the ground, turn off the power supply, arrange the operation site in time. For regular maintenance, check the lubrication status of the lifting chain and pulley assembly every week, replace the aging hydraulic oil according to the specified cycle, regularly calibrate the load limit protection device to make sure the lifting procedure runs smoothly every time.
All the above procedures are fully adapted to the electric forklift products we provide. Jianshu New Energy can also provide users with targeted operation training and full lifecycle supporting service, to help the operation team form safe and standardized operation habits and create stable operation value for material handling scenarios.
