Before conducting any tire replacement, inspection or maintenance work for electric forklifts, operators must receive pre-job safety training and strictly follow the standard operation steps to avoid unnecessary safety hazards. First of all, park the electric forklift on a flat, solid horizontal ground, turn off the whole power system, pull up the hand brake, and place non-slip stoppers on the two diagonally opposite driving wheels that do not need to be operated, to prevent the forklift from sliding accidentally during the whole operation process.
Second, confirm the rated load of the selected forklift jack is higher than the full weight of the corresponding lifting part of the electric forklift, check that the jack structure is intact without deformation, crack or oil leakage before formal use. Operators are not allowed to use unqualified jacks for lifting work to avoid safety accidents.
Third, align the top support of the jack with the special reserved lifting point at the bottom of the electric forklift chassis, never support the jack on the plastic shell, oil pipeline or other non-bearing parts, to avoid structural damage or slipping during the lifting process. Slowly shake the jack handle to lift the target tire off the ground for 3 to 5 cm, shake the forklift body slightly to confirm that the supporting state is stable, then place the special solid support under the chassis to complete the double protection, and then you can carry out subsequent tire disassembly and maintenance work.
After the tire work is completed, clear all tools and sundries under the forklift first, then slowly lower the jack, remove the support and the wheel stoppers, check the running state of the tire to confirm it is normal before you can restart the electric forklift. If you have any demand for electric forklift related operation guidance or product consultation, you can contact Jianshu New Energy, which specializes in BYD electric forklift, via the mailbox 17399989919@163.com for further communication.
