Multi-layer shelf cargo stacking Reach type lithium battery forklift Instructions for use

Preparation before operation. Before using a forward-moving lithium forklift for multi-layer shelf stacking, three core preparations need to be made. The first is environmental inspection, which needs to confirm that the width of the working channel is sufficient for forklifts and goods to pass, there are no sundries at the bottom and top of the shelf, the ground is flat without obvious potholes, water accumulation, oil stains, and the channel is clearly marked. The second is vehicle inspection, go around the car to check whether the appearance of the body is deformed, whether the tires are evenly worn, whether the door frame chain is loose, and whether the fork is deformed or cracked. After entering the cab, check whether the seat seat belt is in good condition, whether the various parameters of the instrument panel are normal, whether the light horn is sensitive to steering, and whether the brake pedal and handbrake are effective. Open the battery compartment cover to confirm that the lithium battery is fully charged and The third item is personnel preparation. Operators need to undergo professional training and obtain corresponding operating qualifications. They should wear non-slip and wear-resistant work clothes and safety shoes. It is forbidden to operate after drinking, fatigue or physical discomfort.

Driving and stacking operation. In the scenario of multi-layer shelves, driving and stacking need to follow specific specifications. When driving, the fork needs to be lowered to a safe height of ten to fifteen centimeters above the ground, the door frame is tilted back to keep the goods stable, strictly follow the driving direction and speed limit in the passage, slow down in advance when turning and observe the surrounding situation. It is forbidden to make a sudden stop or overtake in the passage; when encountering pedestrians or other vehicles, you need to honk in advance and take the initiative to avoid. When stacking, you need to park the forklift at the designated position in front of the shelf, pull up the handbrake, and hang it into neutral gear; adjust the reclining angle of the gantry, slowly lift the fork to the same height as the target shelf laminate, adjust the forklift position to align the fork with the shelf laminate; slowly move the gantry forward so that the fork is fully inserted into the bottom of the tray, and the center of gravity of the tray needs to fall in the middle position of the fork; then slowly lift the tray and goods to a position higher than the target laminate by five to ten centimeters, confirm again that there are no sundries on the shelf laminate, and there is enough space. Adjust the reclining angle of the gantry to make it vertical. Slowly move the gantry forward to place the tray smoothly on the laminate. After confirming that the tray is stable, slowly lower and withdraw the fork, and finally lower the fork to a safe height The door frame is reclined and ready for the next operation.

Key points of daily maintenance. Daily maintenance can prolong the service life of the forward-moving lithium battery forklift and ensure the safety of operation. After each use, it is necessary to clean the dust and sundries on the body surface, fork, and gantry chain, check whether the tire pressure is normal, park the vehicle in the designated charging or storage area, pull up the handbrake, hang it into neutral gear, and turn off the power supply. When charging the lithium battery, it is necessary to use the supporting charging equipment, which is carried out in a well-ventilated environment. It is forbidden to smoke or use an open flame in the charging area. Disconnect the power supply in time after the charging is completed. Check the tension and lubrication of the gantry chain every week, and adjust or add special lubricant if necessary; check the wear of the braking system, and replace the brake pads if necessary.